Low-alloy, low-temperature, Cr-Mo, hardfacing, cast iron, cutting and stainless electrodes – when you need them and what each one does.
E6013, E7016 and E7018 cover most mild-steel work. But some jobs need an electrode designed for one purpose. Using an ordinary electrode there can mean cracks, a weak joint or a part that wears out in weeks.
Cellulosic electrodes – E6010, E6011, E7010
The coating burns to create a strong, digging arc. They are the classic choice for root passes on pipelines, welded vertical-down, and for dirty or rusty steel. E6010 runs on DC+; E6011 also runs on AC. E8010-P1 is the higher-strength version for line pipe.
Improved-toughness – E7018-1
An E7018 that is impact tested at −46 °C instead of −29 °C. Used for structures, tanks and pipes that will see cold service or shock loads.
High-strength low-alloy – E8018-G to E10018-G
For high-strength structural steels used in cranes, earthmoving equipment and heavy machinery. The rule is to match the strength of the steel – a much stronger weld than the plate is harder and more likely to crack.
Heat-resistant – E8018-B2, E9018-B3
Chromium-molybdenum electrodes for boilers, steam lines and refinery pipes that run hot. Choose the alloy that matches the pipe: B2 for 1¼Cr-½Mo steel, B3 for 2¼Cr-1Mo. These jobs usually need preheat and post-weld heat treatment.
Low-temperature nickel steels – E8018-C1, E8018-C3
Nickel gives toughness in the cold – used for LPG storage, cold-climate structures and offshore work.
Hardfacing electrodes
These don't join metal – they build up a hard, wear-resistant layer on parts like crusher hammers, excavator teeth, rollers and shafts. They are graded by hardness (for example 30, 35, 48 and 64 HRC) and by the type of wear. Read our hardfacing basics.
Cast iron electrodes
Nickel-based electrodes give a soft, machinable weld for repairing pump bodies, gearbox housings and engine parts. Non-machinable iron-based electrodes are cheaper for repairs that don't need machining. See welding cast iron.
Cutting and gouging electrodes
Special coatings that let an ordinary welding machine cut, pierce and gouge steel and cast iron – useful for removing old welds and cracks before repair, with no gas cylinder needed.
Stainless steel electrodes
E308L for 304 stainless, E316L for 316 in chemical and food plants, and E309L for joining stainless to mild steel.


