0

How to Choose the Right Welding Electrode

06.10.26 05:54 PM By Varun Menon

Welder Tips6 min readMentrode Welding Electrodes

Steel, job, machine, thickness and position – five questions that pick the right stick electrode almost every time.

Most bad welds start before the arc is struck – with the wrong electrode. The good news: five simple questions get you to the right choice almost every time. You can also try our Electrode Finder, which asks the same questions.

1. What steel are you welding?

For ordinary mild steel – MS plate, angle, channel, pipe and sheet – a carbon steel electrode from the E60 or E70 family is right. Special steels need special electrodes:

  • High-strength steel – match the strength (E8018-G, E9018-G, E10018-G).
  • Steel used in the cold – an impact-tested grade such as E7018-1.
  • Boiler and hot-pipe steels (Cr-Mo) – alloy electrodes like E8018-B2 or E9018-B3.
  • Cast iron, stainless steel, worn parts – each has its own electrode. See our guide to special electrodes.

2. How critical is the job?

Gates, grills, furniture, light frames and general repair are well served by E6013 – easy to strike, smooth arc, slag that peels off by itself.

For load-bearing structures, thick or restrained joints, pressure parts and machinery, choose a low-hydrogen electrode – E7016 or E7018. They put very little hydrogen into the weld, which is the main cause of cracking in thick steel.

3. What machine do you have?

MachineGood choices
Small AC transformer (low OCV)E6013 – strikes and runs easily at low open-circuit voltage
AC machine, OCV 70 V or moreE6013, E7016, E7018
DC machine or inverterAll of the above; E7018 on DC+ gives its best results

4. How thick is the metal?

Use a thinner electrode on thin metal so you don't burn through, and a thicker one on heavy plate so you fill the joint faster:

Metal thicknessElectrode size
Up to 3 mm2.5 mm
3 – 6 mm3.15 mm
6 – 12 mm4.0 mm
Over 12 mm (flat)4.0 – 5.0 mm, multiple passes

5. Which position?

The third digit of the code tells you: 1 = all positions (E6013, E7016, E7018), 2 = flat and horizontal fillets only (E7024). For vertical and overhead work, stay at 3.15 or 4.0 mm and turn the current down a little.

Quick rule: general work on any machine – E6013. Structural or thick work on a good AC machine – E7016. Critical work on DC – E7018.

Still unsure? Send us your job details on WhatsApp and our team will suggest the right electrode and size.

Varun Menon

Items have been added to cart.
One or more items could not be added to cart due to certain restrictions.
Added to cart
Quantity updated
- An error occurred. Please try again later.
Deleted from cart
- Can't delete this product from the cart at the moment. Please try again later.