0

Why E7018 Struggles on Small AC Welding Machines

10.10.26 05:28 PM By Varun Menon

Welder Tips4 min readMentrode Welding Electrodes

Hard starts, sticking and a sputtering arc – why low-hydrogen electrodes need the right machine, and what to use instead.

A common complaint: "E7018 doesn't run well – it keeps sticking." Often the electrode is fine. The problem is the machine.

What's going on

Low-hydrogen electrodes like E7018 and E7016 have a basic (lime-fluoride) coating. It gives tough, crack-resistant welds, but it is harder to ionise than the rutile coating on E6013. To strike and keep the arc going on AC, the machine needs enough open-circuit voltage (OCV) – roughly 70 V or more.

Many small, low-cost transformers in Indian workshops give 45–60 V OCV. That is plenty for E6013 but not for E7018 on AC.

Signs your machine is the problem

  • The electrode sticks again and again at the start
  • The arc goes out when you lengthen it slightly
  • A sputtering, unstable arc even at the right current

What to do

  • Use a DC machine or inverter – E7018 runs best on DC+.
  • Use E7016 – made to run more easily on AC, with the same low-hydrogen benefits (still needs a good AC machine).
  • Keep electrodes dry – damp low-hydrogen electrodes are harder to strike. Re-dry at 300–350 °C for 1 hour.
  • For general work on a small transformer, use E6013 – that is what it is designed for.
Check the rating plate on your machine – OCV (or U0) is usually printed there.

Varun Menon

Items have been added to cart.
One or more items could not be added to cart due to certain restrictions.
Added to cart
Quantity updated
- An error occurred. Please try again later.
Deleted from cart
- Can't delete this product from the cart at the moment. Please try again later.