0

E6013 vs E7016 vs E7018: Which Welding Electrode Should You Use?

06.10.26 11:23 AM By Varun Menon

Welder Tips6 min readMentrode Welding Electrodes

Three of the most common stick electrodes in India – and how to pick the right one for the job, the steel and your welding machine.

Walk into any hardware shop in Kerala and you will find three electrodes on the shelf more than any others: E6013, E7016 and E7018. They all weld mild steel, but they are not interchangeable. Picking the right one saves time, avoids cracked welds and keeps customers happy.

The short answer

E6013E7016E7018
CoatingRutileBasic, low hydrogenBasic, low hydrogen, iron powder
Min. tensile strength430 MPa490 MPa490 MPa
CurrentAC or DC±AC (OCV ≥ 70 V) or DC+AC (OCV ≥ 70 V) or DC+
Ease of useEasiestModerateModerate
Needs re-dryingOnly if dampYes – 300–350 °CYes – 300–350 °C
Best forGeneral fabrication, thin sectionsStructural work on AC machinesHeavy and critical structural work

E6013 – the everyday electrode

E6013 has a rutile (titanium dioxide) coating. It strikes easily, runs with a soft, quiet arc and leaves a smooth bead with slag that often lifts off by itself. It works on small AC transformers with low open-circuit voltage, which is why it is the first choice for gates, grills, furniture, sheet metal and general repair.

Its limit is strength and crack resistance. For thick, restrained joints, higher-strength steel or work that will be inspected, step up to a low-hydrogen electrode.

E7016 – low hydrogen that runs on AC

E7016 has a basic, potassium-silicate coating that puts very little hydrogen into the weld. Less hydrogen means less risk of cracking in thick or restrained joints. Because of the potassium in the coating, E7016 runs well on AC transformers – a big advantage on site and in small workshops that do not have a DC machine.

It has a fast-freezing puddle, which helps with root passes and positional welding. Like all low-hydrogen electrodes, it must be kept dry.

E7018 – the structural workhorse

E7018 adds iron powder to the low-hydrogen coating. The iron powder raises the deposition rate (about 110% metal recovery) and gives a smooth, low-spatter arc. It is the standard choice for structural steel, pre-engineered buildings, pressure vessels, boilers and any joint that needs high strength and toughness.

Tip: E7018 and E7016 pick up moisture from the air once the packet is opened. Re-dry at 300–350 °C for 1 hour and keep them in a holding oven at 100–150 °C. Damp low-hydrogen electrodes cause porosity and hydrogen cracking – the very problem they are meant to prevent.

Which one should you buy?

  • Light fabrication, thin steel, small AC machine: E6013.
  • Structural or thick-section work on an AC transformer: E7016.
  • Heavy structures, critical joints, inspected work, DC machine available: E7018.

Still unsure? Use the current calculator in our Knowledge Centre or WhatsApp our team with your job details.

Varun Menon

Items have been added to cart.
One or more items could not be added to cart due to certain restrictions.
Added to cart
Quantity updated
- An error occurred. Please try again later.
Deleted from cart
- Can't delete this product from the cart at the moment. Please try again later.